Two Channel System Amplifier with DSP, Dante, and Crossovers (500w/ch) Rack Ears Included
While many contemporary amplifiers waste 50% or more of the power they pull from the wall as heat, the SA-series amplifiers run at approximately 90% efficiency. As a result, more power is available for the loudspeaker, and less is wasted as heat in your room. Designed and built in the United States, the SA-2 DSP is a compact 2RU amplifier that delivers two channels of high-performance amplification at 500W per channel into four ohms, all channel-driven. This DSP model adds a DSP board, enabling all eight channels to provide the necessary digital active crossover, delay, gain, and digital EQ profiles, in addition to a Dante Digital Audio Input, and FIR Filters, for the ultimate in sound and loudspeaker setup and EQ.
The high efficiency of the SA-series design also means that the amplifiers can be placed in close proximity to each other, as in an equipment rack, without undue overheating.
SPECS:
| Rated Power Output Per Channel | 500 w/ch continuous rms power @ 4 ohms above power ratings from 20 Hz–20 kHz at <0.5% THD |
| Peak Output Current | > 30 amps |
| Voltage Gain | 31 dB |
| Signal to Noise Ratio (Main Outputs) | –103 dB (ref 1V rms, A-wtd.) |
| Input Impedance | 25k ohms (balanced) |
| Output Impedance | Less than 0.05 ohms from 20–20,000 Hz |
| Input Sensitivity | 1.2V for full output |
| Polarity | Non-inverting, Pin 2 positive |
| Thermal Load | 7 BTU/minute or less |
| Power Consumption | See “Wisdom Electronics – Current Draw & BTU Info” in the “Resources” Section below |
| Main Voltage Ranges | 100V, 120V, or 230/240V determined by the needs of country for which the unit was manufactured; cannot be reset by dealer or user |
| Shipping Weight | 40 lbs. (19 kg) |
| Dimensions – HxWxD | 3.75” x 17” x 13.63” (8.57cm x 43.2cm x 34.7cm) |